I bought a Kubota KX41-3 in 05. It has a 16" bucket,boom hydraulics, Hydraulically adjusted track width from 35" to 54" outside measurment,and independant boom and house swing. I bought a LOWE hydraulic auger for it, and built a detachable thumb for it. It's only limitation is loading dirt into bigger trucks, which you can't, but works well with standard 1T dumps. I have never done anything other than routine maintainance to it. Been a great machine for ditching, foundation work. The hyd auger is great for setting posts and forming round holes for concrete piers. It will only turn a 9" auger in our heavy clay ground, but reverse is real handy if you catch a rock, and when it is pulled from the hole to clear the flighting. You may be able to buy a unit from a dealer that maintains a rental fleet as I did. Kabota had a rental program for dealers which worked very well for me, and a lot of the rental hours prior to my purchase was clocked by myself, kinda pay as you go, and then a good finance program at the end of the season.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
