Posted by greenbeanman in Kansas on March 12, 2011 at 08:30:57 from (67.66.110.238):
In Reply to: hayloader posted by Teresa C on March 12, 2011 at 07:42:24:
Teresa, I doubt that the square bale loader will bring much as it has a number of things against it.
Square bales are simply not used a great deal in many areas so demand is much lower than it used to be.
It appears that this loader does not have a driven chain to pull the bales up the conveyor, but instead relies on one bale pushing against the next one to force it along. At least I don't see any chain mechanism although there does appear to be a sprocket on the axle.
The driven chain units are either ground driven or drive by a small gas engine. I prefer the latter but have hauled bales from both kinds.
For those that might not know--the axle/wheel end is where the bales enter. The guides help to align the bale with the ramp. The end nearest the camera attaches to a truck bed or wagon and the guide turns the bale to move it onto the small platform where it awaits being picked up by a bale worker, are is pushed on off by the next bale.
Though photos can be deceiving, this unit is sure different than any I've seen before. To me it appears to have a very sharp rise angle to it.
Don't have a clue to value since it isn't chain driven. Sorry.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.