Paul, After seeing the pic of your 3020 LP, slide out the tires to the outside of those axles, the part that sticks out past the hubs now isn't there for an ornament! Go the your local tractor wrecking yard and get at least 6 more wts,3 sets, so you will have a total of 4 on each rear corner. The biggest cost will be the JD wt bolts you will need to get from Deere. My local tractor wrecking yard sells JD wts like your the last time we go a set was about $45/set of 2. If my memory serves me right the cost of all the wt bolts will be about like buying a set of 2 wts all by them self. I have a Hat Rule here at the House if I walk a round a tree and a limb touches my Hat,,, off it goes. Out in the pasture or fields and a limb touches my Hat while I am on a tractor Off it goes or the tree get pushed out. Just be judicious in your limb trimming or tree pushing!LOL As far as low hanging limbs carry a chainsaw or Polesaw and start cutting all limbs that even get close to touching your hat while you are sittin an your tractor, also............ Take Off Your Muffler run it without or some sort of short stack while you are up close and personal with the limbs. I know for I have ruined and half soled a couple of mufflers over the last 20 yrs or so Hope this helps. Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
