Not just yet for us over here in the buckeye . My buddy and i were talking this evening that MAYBE , just Maybe we might be able to start to clean the barn IF we don't get a bunch of rain. As for anything else not this week . I have a ton of work to do on the new to use disk chisel and then there is the let's fix the wing on the 470 I H disc that a weld let go on one of the wings and it is sprung and will need a lot of work to get it back in place before i put the Lincoln ready bolt to it . Then there is the spring service to all the rolling stock plus the need to a new set of 18.4x38's for the 1066 and a new set of 18.4x34's for my 806 . And as soon as the parts get here for the chisel we will get on that first, now as being able to pull it That is yet to be seen , not sure if we have enough pony power yet. It is a Landoll that has had some shell we say BARN YARD engineering done to it and now is sporten 5 DMI Parabolic shanks with 5 inch Tiger points. Got to do some work on the wheel lift .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.