Posted by RayP(MI) on April 01, 2011 at 11:03:24 from (207.241.137.116):
In Reply to: CF belt drum mower. posted by Bendee on April 01, 2011 at 01:04:18:
I am firmly convinced all those canned penetrants are more hype than results. Had a bunch of nuts that needed removal, a few years ago. Since I had a selection of penetrants setting on the shelf, I tried several. Applied several times over a couple week period. Kept track of which one was used on which nuts. Didn't make any difference. None actually penetrated the threads. Included were WD-40, and PB Blaster. They were none better than a little common ATF, or plain oil. Did not try acetone, and oil mix. My best results for some uses is heat with a propane torch, and melt candle wax into the threads. Then work back and forth to loosen before working it too hard.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.