Posted by Wardner on April 08, 2011 at 01:12:06 from (4.154.251.153):
In Reply to: Sand Blast Machines posted by Wilks54 on April 07, 2011 at 14:38:59:
I am a retired sandblasting contractor. I never bought a factory blast pot because they were overpriced and they under-performed. OK, I take that back. I did buy a 20 ton shipyard unit at auction with six outlets but I made alot of alterations.
I am partial to Thompson valves sold by Schmidt. The erodible parts are made of tungsten carbide and last for years of constant use. I used to pay $600 for them. The air valves were full throat ball valves with air-actuated operators.
For a part timer or hobbyist, I suppose anything will do.
You will save alot of sand with remote controls. You will also save time and aggravation should the mixture go lean. The flow can be restored with a quick off/on using a feather-touch 3-way valve at the end of the hose. Tungsten carbide nozzles are worth the money. Use self-grounding (static electricity suppression) sandblast hose with sandblast hose couplings. And don't skimp on an air-supplied helmet and ear plugs.
If you get set up properly, you can make some money and remain healthy. I am in good shape (including hearing) after 30 years of running 750 CFM @ 125 PSI. Your biggest time saver will be using the largest pot you can. There is less need to stop or indulge yourself with a break. Time flies when you are making money. A four ton pot will run all day without reloading. Buy bulk sandblasting sand if available.
Use eBay to get pricing on equipment. Don't forget the eBay "completed listings" too. If you want to build a pot, look at air receivers or propane tanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.