Posted by Louis Torrans on April 10, 2011 at 20:56:33 from (70.254.32.46):
In Reply to: Shot Gun Question posted by Whiskey Bent on April 10, 2011 at 18:48:40:
There's no one easy answer for this. Your gun may have a very short choke and the forcing cone may be short too. If either of these is too short it compresses the shot column too quickly and the shot over deforms and can spread out quicker and in a poor pattern. Does your gun kick harder than your friends? If yes, the forcing cone may be too tight and too abrupt. Most off the rack guns of less cost have this issue. Could be the gun does not fit you and the sight line is not natural. Do you shoot better with your friends? Are you shooting discount store field loads? These always give poorer performance. Go see a gun smith that deals in shot gun repair and modifications. Or, trade the gun for something a little more upscale with improved features. There's always some shot gun gurus around a trap and skeet or sporting clay field. Drop by and ask for some help. The good ones will be willing. The smart asses will be the dumb ones. Once you've shot enough powder and lead to be hip deep in hulls, then you'll be good with a shot gun. Once it makes since and you can actully feel the shot before you pull the trigger and you seem to have more than enough time to make the shot, then you'll be getting real good!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Antique Tractor Wiring Basics - by Curtis von Fange. One of the most neglected parts of old tractors is the wiring. After sitting in the elements for half a century or more much equipment wiring has deteriorated to sparsely covered strands of copper or other metal. Plastic insulation has cracked, mice have eaten through the older clothed style coverings and the exposed wires have reacted to winter moisture and salts by turning blue and powdery. Terminal ends have corroded, rusted or just plain evaporated away. Aged wires not only keep an engin
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
