NAPA carburater kit # 2-1565 fits virtually all Wisconsin 2 cyls with Zenith carbs, as well as 4 cyls, models, VF4,VH4,VH4D,. If you repair your carb, be sure to soak it well in carb cleaner. I've used denatured alcohol, or MEK with good results to cut the varnish. Use a fine wire to make sure all of the passages are open. A gas welding tip cleaner, that has about 20 sizes of fine wires works well. Finally...the valves on those engines are prone to sticking, if they sit for lond periods. If my engines are going to sit I pull the plugs and squirt some oil along the valve stems. A quick check is to pull the head. NAPA head gasket kit # 7623S is "about $15. a complete gasket set is also available. I always open the base and usually find them full of sludge and crud from use of non detergent oil, It's worth the time to clean them out. I use SAE 10-30 oil in everything with no problems.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
