Just because it can be used at a higher duty cycle on a lower setting, doesn't mean it isn't rated as a 20% duty cycle machine. Otherwise every machine made would say 100% duty cycle. I think the AC 225 can be used at 100% for only one 10 minute period and then has to cool off. Duty cycle isn't continuous. "Darn near indestructable". Maybe in a farm or hobby shop with occassional use it could last a long time. In a welding shop it could be toast in 5 minutes.
A lower cost way to cut metal? How about a thin cutting disc in a grinder. Faster, highly accurate and much cheaper than using a 220 volt welder. Everybody that welds should have a grinder. A sawzall does a nice job too.
I made a slight error on the smaller version AC 225. It's an AC 225 GLM with lower duty cycle rating than the standard AC 225.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.