Posted by Inno on April 20, 2011 at 14:54:51 from (70.54.184.7):
In Reply to: Machine Shop Rates posted by Inno on April 20, 2011 at 12:55:18:
Here are the details of the work done.
On Saturday I brought in two pins from the bucket of my backhoe, four bushings from same and two pins and bushings from the front end loader, which had grease nipples and required drilling a hole for greasing.
I was not in a hurry, he told me they would be ready Tuesday. I said that was fine. I did not ask the price because regardless, I needed them.
The materials list is as follows:
-16.5" of 1 1/2" of "prec" shaft (it's hand written, prec is the nearest I can figure)
- 9" sm 2 1/2" x 1 1/4" tubing
- 1/2" sm 2x1" tubing
- 1" nuts (2)
- 1" toplock nuts (2)
- 1" flat washer
- 9" 1 3/8" prec shaft
- 7" 1 1/4" prec shaft
- grease nipples (2)
Materials total $130
Labor to machine bushings & pins $346
Total $476 plus tax
When I get home I can take pictures of the parts for reference
I did not ask what the hourly rate of the shop was, I probably should.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
