Posted by Jme houston TX on May 03, 2011 at 19:13:16 from (70.139.152.40):
I just rebuilt my cav injuctor pump. would like to share some info to anyone who whats to give it a try. First buy the complete kit on-line with all the rebuild parts. There is a plastic screen in the pump inlet that no one talks about, and mine was completely plugged. my tractor was loosing power and would not power up I suspect it was the plugged screen not letting the pump get enough fuel. I did not change or adjust any of the parts inside only changed orings and seals. all of the seals were easy enough to change except for one. The body and the head unit oring, it is trapped between them. So not knowing how to get it out I did not replace it and guess what it was the only place leaking after I installed pump back in the tractor. To replace this oring you need to pull off the top cover, and carefully remove the spring that is in the cover and rember which holes they go in, and make sure the fuel cut-off slider stays in place Remove the inlet pipe take out the pump vanes and parts. Then remove the three bolts that hold the head unit in place. the back bolt, the bleed screw bolt and the bottom bolt. then gently turn the head unit and remove the arm in the top cover that is held in the head unit. the head unit will now slide out, so you can clean the parts and replace the oring. this took me 6 hours to figure this out hope this helps the next guy. Cav has a good rebuild instructions but does not have very good pictures. some tractor parts sellers sell all the parts indivdually and they have a good parts picture. good luck rebuild will save you $650.00
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
