I would say take that apprentice position with the idea of taking one collage corse at a time in your basic needs for any collage degree of any type and after the 4 years are up and you have a jump start at collage then take the same corse as you are thinking about or if you so desire after getting some experiance change for a different degree. After working at it for a while you may decide it is not for you so why pay for 2 different collage degrees. You will still have the degree but you will also have a work history that will be valuable as it seams that a lot of collage grads cannot get the job because of no work history. If you decide to go straight to collage get a work history while at school even if it is just stocking shelves at the local grocery or flipping burgers but get that work history. From a guy that left high school in 1959 at end of sofmore and before junior year and farmed all life untill lost the farm and could only get a job delievering newspapers and befor I hung it up last year I was spending more to keep doing the job than I was making. I did not have a work history so no one wanted to hire me for any job. My father-in-law was a pharmist all his life but He started collage to become a dentist for 2 years untill he went in the milatary and after he was out could not get in denistry collage so switched to pharmacy and with 6 totall collage years the first 2 were wasted, would only have paid of if he had gone anouther 2 years and became a doctor but after 6 years of collage he said enough of that. So with all this said get your work history first and then decide what you want to do and from every thing you hear the people that waited till in there 30's all did a lot better in collage than the ones that went direct from high school.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
