|
Farmall & IHC Tractors Discussion Board |
Re: Re: FARMALL SUPER M 12V CONVERSION - BOB MELVILLE
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tennessee Transplant on January 31, 2001 at 11:06:03 from (152.163.201.206):
In Reply to: Re: FARMALL SUPER M 12V CONVERSION - BOB MELVILLE posted by Bob M(elville) on January 28, 2001 at 19:18:55:
Bob: Hit a snag in the re-wire....The
tractor starts but will not shut off.
...When I removed the voltage regulator,
I noted that the tractor would not start
or run unless you tied the two wires that
went through the Voltage Regulator...I
rewired them to each side of the ignition
switch in hopes of curing the problem...
No Joy...where have I gone wrong....and
before you answer...here is more fly in
the ointment....I installed a PERTRONIX
solid state Ignitor and put on a CBS
40K Coil (has ballast resister so the
instruction sheet says)....I opted NOT
to install a warning light...just running
through the OEM Ampmeter...(which is driven
off the peg with the Alternator charging)...
....SOS guy . ...?? dave
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
