Farmall & IHC Tractors Discussion Board |
Re: Re: Attn: The Red, Bob M., Old Sparky, Anyone Else Interested
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George on February 18, 2001 at 06:23:52 from (207.75.138.43):
In Reply to: Re: Attn: The Red, Bob M., Old Sparky, Anyone Else Interested posted by RB on February 18, 2001 at 04:33:16:
Coil +or-????? the coil will work either way BUT when the polarity is not correct the points will not last quite as long ,I have some liturature from way back in the late 50's that explaines this. If the coil polarity is correct the point build up will occur on the fixed point, And the moveable point(The one that rubs on the cam) will crater. Most of us will have to use a magnifying glass to see this. As our tractors are not run many hours like the autos and trucks of yesteryear this will not be too apparent,And probaly not persent a problem. Also the heat buildup in points yrs. ago caused many to go to "vented points" (the points had a small hole in the center of them) also much like polarity switches in welding, one can dissipate heat in to the grounded point (fixed one)much more readly than the moveable one Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|