Farmall & IHC Tractors Discussion Board |
Re: Re: Blade for a Super C?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on February 20, 2001 at 11:30:24 from (209.215.43.48):
In Reply to: Re: Blade for a Super C? posted by Steve K on February 20, 2001 at 08:42:35:
Steve, thanks for the info. I have a 6 foot two pt. hitch blade for the rear that works well. I was just looking for something that would be good in the snow. I don't get alot of snow where I am, but enough to where when it does snow alot of extra side money can be made to waste on these tractors! I was also considering a blade for the front of my Case 730 or Case IH 385 tractors. I just thought I could find one cheap and easy for the C, that I can leave on during the winter, cause I don't use it much that time of year where the other tractors are used often and a blade in the front would be a hassle. I will keep you posted if I find out anything more.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|