Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 123 power unit in a B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve T on March 25, 2001 at 07:51:47 from (216.229.166.144):
In Reply to: Re: Re: 123 power unit in a B posted by lee on March 23, 2001 at 17:52:11:
Hi Lee, Yes, that is why there is a cut out on the block. Some power unit engines had a plate under the mag for a hydraulic pump, why I dont know. Also, some of these engines needed a fuel pump and there is a 2 bolt plate on the side of the block under the mag for a pump. When I was rebuilding the engine for my "A", I noticed that the camshaft had an extra lobe for the fuel pump, even tho the block wasnt cast for a pump. On the front, right side of the engine right under the cylinder head , and above the mag is where the engine size is cast. If the engine is a C-113, there will NOT be a casting. However, if its a C-123 or a C-135, these numbers will be cast in the block
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|