Farmall & IHC Tractors Discussion Board |
Re: Darned if I do. Darned if I dont.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on March 30, 2001 at 08:18:37 from (209.130.148.157):
In Reply to: Darned if I do. Darned if I dont. posted by Nick on March 30, 2001 at 06:39:26:
I cracked the transmission housing on my H a few years ago from ice in it. The crack was where the bottom curves up to the right side. It was a 6 inch crack. I tried JB Weld and it would hold for about a year, then start to leak. I finally called a professional welder and he did a real nice job of fixing it. I had him do a couple of other minor jobs when he was here and the whole thing cost me $60. A good welder can fix it but not all good welders can weld cast iron. Make sure if you get someone they know about cast.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|