Farmall & IHC Tractors Discussion Board |
Re: 1942 'Old Rusty' Farmall H Update
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red. THANKS! on April 27, 2001 at 04:07:44 from (12.75.197.91):
In Reply to: 1942 'Old Rusty' Farmall H Update posted by The Red on April 26, 2001 at 15:31:08:
I forgot to mention that I have been rocking one rear tire. I get about 5 degrees of movement on the axle but that is all transmission slop. So far none of the pistons are budging. I'll give the Marvel another week or so and then switch over to the PB Blaster or something else. John Nichols had PB in there but probably not enough. The bottom of the pistons look brand new. I still don't think Old Rusty had many hours on it's last overhaul before it got stuck. But it might have been stuck for over 10 years!
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|