|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: about to give up - - -engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gene on May 23, 2001 at 10:40:08 from (205.188.192.151):
In Reply to: Re: Re: Re: Re: about to give up - - -engine posted by George on May 23, 2001 at 07:37:21:
George: Thanks for your help. No, the IH 464 I have has a C-175 4 cylinder engine. As far as compression tests, the last one I ran was on a warm engine. Book says should be 170, compression ranged between 155 and 163 or so. Never have run it on a hot engine.
You mentioned an adjustable main jet from an "M" carburetor, or 400 or 450. I wonder if it work on the tractor of mine, governor linkage, and all. I certainly would love to try it. I had asked the IH dealer if a variable adjustment of the main jet was available and they said no. I even tried different size jets that were available for the MS carbuertor. I had the smaller one in it - when I got the other jet I installed it anyway - made matters worse. I have a lot of spare parts left over with no solution. Again, thanks - I will call Case/IH again to see if there may be another carb that would fit, or maybe somehow adapt the carb I have to a variable main jet.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
