|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Farmall H Steel Belt Pulley? Is there such a thing?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Thanks Andy on May 24, 2001 at 17:18:21 from (64.20.91.7):
In Reply to: Re: Re: Re: Farmall H Steel Belt Pulley? Is there such a thing? posted by Andy Martin on May 24, 2001 at 16:59:26:
Andy: Nice to know there are still a few flat belt users around. I always liked running flatbelts. I ground feed a lot with a SMD on a flat belt and being younger back then(1950's) I'd make her smoke a little now and then and watch the belt dance(swing) I also like watching steam tractors work on a belt too.. I cringe a bit watching some try and line up a belt for the first time. Takes a sharp eye. ralph
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
