Farmall & IHC Tractors Discussion Board |
cub cyclinder head
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave F. on May 24, 2001 at 23:13:25 from (4.47.58.148):
On my 48 cub I did an valve job, while bolting the head back down one of the head bolts (#8) pulled the threads in the block, I redrilled the bolt hole & installed an helicoil put it back together water leaks up past the bolt head & I have some water seepage, I torque the bolts at 45ft.lbs also when I can get the engine to start it runs a short time & quits and won't restart have good spark, plug wires are connected right carbureator ok, any help will be greatly appreciated thanks in advance, any Farmall / cub people located in or near Morgantown, WV
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|