Farmall & IHC Tractors Discussion Board |
Re: HELP, Trying to Adjust Wide Front End on Farmall A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by george Willer on May 27, 2001 at 05:48:10 from (64.254.131.58):
In Reply to: HELP, Trying to Adjust Wide Front End on Farmall A posted by Little Bubba on May 27, 2001 at 01:09:59:
Little Bubba, Keep in mind that this tractor is a female! Leave the clamp off, and drop a smaller bolt in the hole where the pin goes. Drive it around a bit and it will loosen up. In the worst case, you might have to wait till next winter when it is moving snow and you really need it. It might help to pray for it to remain solid. Murphy's law rules! George Willer
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|