Farmall & IHC Tractors Discussion Board |
Pits, Primers, and Paints???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bama Binder on June 25, 2001 at 11:22:13 from (206.5.110.200):
I have a few painting questions as I prepare my Super H for some badly needed paint. First..I am either sandblasting or using a wire wheel to get old paint and rust off. In the event I miss some rust, I was thinking of spraying with a rust inhibitor. Questions... 1. Is there a primer that turns rust to an inert material AND fills in minor pits AND is compatible with either IH red paint or a primer that is compatible with IH paint. 2. Is there another primer / paint combination that will work to inhibit rust, fill in pits, and is compatible with a good quality Farmall red color paint? 3. Is any of the above solutions available in spray cans for painting small parts as I pull them off, sand blast them, and eventually put them back on before the final top coat over the whole tractor? 4. Any other suggestions? My goal if to have a reasonably good looking machine that will last another 50 years. It will be stored inside unless the barn brns down. Thanks guys!! BB
Follow Ups:
- Re: Pits, Primers, and Paints??? Bama Binder 05:34:29 06/26/01
(1)
- Re: Pits, Primers, and Paints??? Zonie 21:31:27 06/25/01
(0)
- Re: Pits, Primers, and Paints??? Red Raider 19:39:17 06/25/01
(0)
- Re: Pits, Primers, and Paints??? BillD 17:15:40 06/25/01
(0)
- Re: Pits, Primers, and Paints??? 230,H,M 15:12:40 06/25/01
(2)
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|