Farmall & IHC Tractors Discussion Board |
RE: Hydrolics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Slappy on September 08, 2001 at 07:16:33 from (143.88.58.77):
I finally got my 44 'H up and running pretty good so we can put it to work with a bush hog. A friend of ours brought his 5' bush hog over for us to use... a fairly heavy unit he got from the county. When I connected it to the tractor I found I have two problems. 1) I don't know squat about hydrolics 2) I've got oil running out of the system Heres the deal. The cylinders have two 'connectors' on them. A lower connector to which the pressure hose from the belly pump is connected, and an upper connector which has an open ended rubber (overflow?) hose connected to it. When I lift the bush hog, the hydrolics stutter a little and oil comes out of the left rubber (overflow?) hose. Here are my questions. 1) Is the bush hog too heavy for my tractor? If so... 2) Can someone tell me the horse power of a 44 'H, so I may better match implement to tractor? 3) Is there a problem with either the cylinder or the pump that needs attention (the hydorlics work fine with our disker, but its lighter than the hog)? 4) Could there be a problem with the vent? The manual calls for the hydrolic cap to have 'packing' in it to prevent dust from getting in through the vent hole. I cut a piece of lawn mower air breather sponge and put it in the cap... problem here maybe? Any advice from the group would be great. Thanks in advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|