Farmall & IHC Tractors Discussion Board |
H carb ID help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Richard C on October 03, 2001 at 06:31:50 from (208.31.95.1):
I just got a very nice new manifold from steel wheel ranch for my 41 dual fuel H. I went to put it on and it slid on great except that I had to back out the studs alittle so they would be long enough. But then the darn carb didnt line up. The flang on the base of the manifold is too big,So that only one bolt would go in. So my question is.. Is it carb or manifold? The only #'s I can read on my dirty carb is 6212-DB. What does this go on if not my H? By the way it is a gas manifold. and not the dual fuel. A new repro one. I was hopeing to have it runnin soon. But I guess not now. Thanks guys Richard C
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|