Farmall & IHC Tractors Discussion Board |
Lowering an A or Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Daniel on November 15, 2001 at 16:48:39 from (64.12.103.177):
Ever since seeing a Cub lo-boy I've thought about getting an A or Super A and letting it down to use with a Woods mower. The lower profile would make getting under trees much eaiser, especially if one runs the exhaust underneath. After seeing Hass's shop mule picture I think rotaing the rear drop housings would work for the rear but does anyone know if new bolt holes would be needed in the transmission to bolt up the housings? I think a machine shop could cut down the front spindles and tubes but not sure if the tie rod ends would clear the front tires then. The other obsticle would be mounting the mower brackets since the pads on the drop housing would change position and the rear draw bar would need some adjustments. I think the A would be a better choce since hydraulics aren't really needed with the mower. What do yall think, is this a crazy or bad idea? Any ideas on if it would work? Why or why not? And if you ask "why not just get a cub lo-boy?" The seem to be hard to come by and even alot of regular cubs are priced higher than an A or Super A, I saw one bring $3550 at an auction this spring. Plus the A will eaisly pull a 5' deck and it would be a good project. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|