|
Farmall & IHC Tractors Discussion Board |
Re: 400 pto clunk
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bill on December 23, 2001 at 18:49:43 from (24.237.152.220):
In Reply to: 400 pto clunk posted by John on December 22, 2001 at 19:33:51:
I had the same problem with my farmall 400 when I had my bales to tight using a New Holland 69 or my 273. I never did figure out where it was coming from but it sounded like it was right under my feet. After I lightened up a bit it quit. Maybe we where just working them to hard. If you find out what your problem is please let me know. Sorry I couldn't help any more than that. How much of a problem was it for you to put in the new TA and what did it cost? I need one too. I don't really work her that hard so I haven't really need it, so I put it off figuring it will do no harm.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
