Farmall & IHC Tractors Discussion Board |
Re: Farmall H stuck in gear(s)?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chuck Puett on December 24, 2001 at 16:18:52 from (207.193.243.95):
In Reply to: Farmall H stuck in gear(s)? posted by Chuck Puett on December 24, 2001 at 11:05:41:
Thanks Dave and Bob! I got it unstuck. However, even after aligning the shift rails to neutral, the tractor still seemed to be stuck in gear(s) and would stall when the clutch was let out. I moved the shift rails into 5th gear position, used a bungee to keep the clutch disengaged, and then pulled the tractor a short distance (with the coil wire off); that apparently unjammed the gears. And yes, the pawl on the shifter is definitely worn, especially on the front edge. Thanks again!! Now I have another question. I've noticed that when the clutch is disengaged, whether in gear or out, there is a knocking noise apparently coming from somewhere in the clutch assembly. The noise stops when the clutch is engaged. What's the problem here?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|