Farmall & IHC Tractors Discussion Board |
Re: Hey Nebraska Kirk, - Live Hyd. Pump Farmall M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by in-a-bind on February 21, 2007 at 00:19:47 from (170.93.140.8):
In Reply to: Re: Hey Nebraska Kirk, - Live Hyd. Pump Farmall M posted by Nebraska Kirk on February 20, 2007 at 21:23:17:
Kirk, When I put the M&W pump on my "H" (20 some odd years ago), I diden't change the cam gear. I am the only person that runs my tractor, this may help me in a lot of ways as I try to take care of my equipment. I don't hold the hydraulics open after the loader or three point has run it's cycle, or put a (as we call it) a heavy load on the pump. I did install a priory valve (sp) that runs the power steering. My brother has a M&W pump on his M, but it was on the tractor when he bought it some 35 years ago. He has never replaced anything but oil, filters, points, and such. The tractor was rebuilt just before he bought it from our uncle's estate. Some people may advise otherwise, I don't know for sure. Maybe "Wardner"(sp), D. Slater (sp), or others may be able to answer this question much better than I can. If I were you and I wanted that pump, I would use esnipe, or whatever snipping service you wish to bid on it in the last 3 or 4 seconds of the auction. esnipe charges a penney on the dollar for their services. You set whatever you think is the MOST that you want to pay for it and then wait until the auction is finished. When its over you either get it or someone else has outbid you. Some people don't like snipping, but I don't have the time to set at a computer with a stop watch and try to bid on things at the last second. Hope this info is of some use for you. Good Luck, Please keep up posted.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|