Re: IH 140 - Dist to Alternator conversion: Brack

Posted by Hugh MacKay on February 25, 2007 at 06:50:07 from (209.226.247.92):

In Reply to: Re: IH 140 - Dist to Alternator conversion: Brack posted by SuperA-Tx on February 25, 2007 at 05:55:58:

Randy: My alternator is a GM delco, it sits exactly same place as the generator that was on there, and the alternator drive pulley is 1" from the factory shroud. The alternator is below the factory hood and the back side is about 1" from engine block, just enough room to allow the throttle linkage to operate freely behind it.

The mount I fabricated for this cost me less than $20. By using the double GM pulley, it lines the old brace for tightening belt perfectly. I put it on 3 years ago, tightened belt once, and it's been trouble free ever since.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]