Re: Governer on Farmall B

Posted by gene bender on February 28, 2007 at 09:06:02 from (67.55.226.214):

In Reply to: Governer on Farmall B posted by GNB on February 27, 2007 at 18:45:03:

Pull the gov housing off and be carefull not to move the gear as you can get it out of time. The input shaft can be rebuilt by machining the hole to 5/8 and pressing a brass bushing in.get a new gov spring and you will be set. Now to adjust linkage with engine off remove the clevis going to the carb. Open throttle all the way. Now hold the clevis linkage open and adjust the clevis pin goes in without moving the out-put lever on the gov and you will have good throttle response. If you need a rebuilt housing send an e-mail as i have some rebuilt and painted ready to go.

Replies:

• Re: Governer on Farmall B Red Dave 11:29:44 02/28/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]