|
Farmall & IHC Tractors Discussion Board |
Re: wide front and hydraulics for a B ?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by riverbend on February 28, 2007 at 19:01:38 from (208.160.33.4):
In Reply to: Re: wide front and hydraulics for a B ? posted by Red Dave on February 28, 2007 at 17:19:37:
I would want to take the wide front off my C and put it on the B. I'd leave the steering boxes as is. As I recall, the bottom of the upper bolster had two empty holes infront of the four where the lower bolster bolts on. They would take the center arm that holds the inner tie rod ends. I should have looked underneigth to see of there were tapped holes to hold the saddle for the pivot for wide top tube. Greg
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
