Farmall & IHC Tractors Discussion Board |
Re: Snap On Duals
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John A. on March 01, 2007 at 21:30:45 from (65.142.251.132):
In Reply to: Snap On Duals posted by Caistor Centre Guy on March 01, 2007 at 10:28:58:
C.C.G., Last April I picked up a set of Smap-on style duals at an Auction about 80 miles from me. As most guys here will tell you is....The Snap-on style are Not highly prised usually unless they have a bunch od tread left on them. I was prepared to go fairly high. The Auctioneer started out high and No one bid, he kept comming down till I bib! No one else bid, so I got my set. They look real close to Allans set in his pic. But my set has maybe 30% rubber. OBTW I only gave $2.50 for the pair TOTAL. What I didn't get were those Eyed-nuts just like the ones in Allans pic. Those little Jewels run about $4.00 ea from Underverth Mgf Co. All eight cost $32 then $4 shipping so the setup I have has been very cost effective. I will bet you can get a set given to, of bought cheap. Mine have 4 J-bolts that secure each to the mounting wheel, at some point I will add 2 more /wheel to keep them tight, mine tend to keep loosening up and working back and forth. Good Luck. Later, John A.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|