Farmall & IHC Tractors Discussion Board |
Re: A little OT: Freeze plugs?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ron in Nebr on March 09, 2007 at 22:29:49 from (66.252.113.150):
In Reply to: Re: A little OT: Freeze plugs? posted by JayWalt on March 09, 2007 at 17:21:11:
Jay, it's your engine and if the rubber plug is what you're comfortable with, and like ya said you don't expect to have it for another 100K miles, no problem. If it works, it works. Since you've already installed the rubber one, it's all a moot point now anyway, but just wanted to point out for others in the future that in my experience, the rubber ones were intended to be used, like Allan said, as an "emergency" fix, kinda like those clamp on battery terminal cable ends, in places like behind a motor mount where there's no room to drive a steel one in. Beings you have your transmission out and I assume the flexplate off, just figured it'd be super-easy to install a steel one there. Even if you weren't comfortable putting it in I bet some local mechanic would have come pounded it in there in exchange for a cold beer... Your point about corrosion/scores in the hole is good, but we'd always just run a bit of scotchbrite around in the hole on our finger and never once have had a problem. If a person was especially concerned about this, the brass ones would be even better- they'd conform to minor irregularities in the hole. Plus they'd never rust out. The steel ones aren't only doing their job in mass-produced engines, there's hundreds of thousands of 'em out there in rebuilt engines that work just fine too. Not an engineering flaw, just the lowest-cost, simplest, way of doing something effectively.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|