|
Farmall & IHC Tractors Discussion Board |
thermostat assembly
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dave2 on March 21, 2007 at 16:20:59 from (139.139.35.70):
Hi folks,
My tractor is a German built model with a 3 cylinder (1.8 liter)diesel. The thermostat is connected in the upper radiator hose (about 1 1/4 inch)with a smaller bypass connector that goes to the lower radiator hose. The whole assembly is about the size of a pony beer can. The link below has a picture of the tractor (unfortunately not mine) if it helps to compare.
I need a thermostat, and was told today by the dealer that they are no longer available. I'm wondering if the american models have anything that compares. Or, can I just do away with the thermostat without ruining the engine?
Any advise is appreciated. Dave
http://homepages.compuserve.de/matbush1710/01_schlepper/326/326.htm
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
