Farmall & IHC Tractors Discussion Board |
Re: To chadd - re gauges
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by chadd on March 28, 2007 at 08:28:20 from (155.92.32.35):
In Reply to: To chadd - re gauges posted by Cedric on March 28, 2007 at 03:54:01:
I looked back at my previous post, and I had written that the range was 170 to 220. There are several gauges listed. The parts numbers are as follows: 393478R91,170-220 degree range for use with 165 to 195 degree thermostat, 130 series tractors 536960R1, 170 to 220 degree range, for use with 165 to 195 degree thermostat, 140 series tractors 406989R91, Electrical gauge?, 120 to 180 degree range, for use with low boiling point thermostat, 100 and 130 series tractors 406884R1, 120 to 180 degree range, for use with low boiling point thermostat, 140 series tractors. As to it being annoying seeing the pointer in the cold area, that was normal back when the tractors came out. It says right in the owners manual that any tractor with a gasoline engine was supposed to run 7/8 of the way into the cold range under normal conditions. However, anywhere in the run range was also acceptable. The kerosene tractors were supposed to run hotter, and hence, the run range was designed for them.
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|