Farmall & IHC Tractors Discussion Board |
I Will Defer...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by A. Bohemian on April 13, 2007 at 12:11:13 from (207.170.88.56):
In Reply to: Re: Farmall A HAND CRANK KICK BACK posted by John T on April 13, 2007 at 11:43:09:
...to your opinion, John T. You are an engineer and I am only a technician. Quote: "The so called "Lag Angle" is how much the static start (impulse) timings Lagsssssssss the advance run timing and its adjustable." Got it, and thanks. So if the advance run timing is, say some number of degrees before top center, the start timing would be 35 degrees behind that? I"m fairly sure of one thing; when hand cranking an engine, the timing MUST be such that the spark fires after top center. Otherwise, you"d have a very dangerous situation. As I"ve noted, on engines with manual spark advance, the engine does indeed sputter and often die before you can advance the spark.
Replies:
Home
| Forums
Today's Featured Article -
Introduction to the Gibson Model D - by Brandon Burnett. The Gibson Manufacturing Corporation was founded 1946 by Wilber Gibson. The Gibson tractors were made from around 1948 to 1952. The picture shown here is of a 1948 Gibson model D. If you notice, this tractor is driven with a lever. You could get a attachment to convert it to a steering wheel.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|