Farmall & IHC Tractors Discussion Board |
Re: MM guy working farmall
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by City-Boy McCoy on April 14, 2007 at 16:06:03 from (68.221.177.158):
In Reply to: MM guy working farmall posted by Dale Hollen on April 14, 2007 at 15:07:32:
The "K" in the 2-25-K makes the engine - and most likely the entire tractor - a 1941. The first time I ran into an A or Super A with the "H" type seat, I thought I was witnessing some Barnyard Engineering. But, I have seen it several times since and I am fairly convinced it was a not-too-common seat option. Often the ID tag will be riveted on that type front seat support, down near the front of the operator's platform - near the pedals. However, I looked one over last weekend with that seat and there was no ID tag anywhere that I could find. It was a 1951 Super A. mike
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|