Farmall & IHC Tractors Discussion Board |
Re: Super C Fuel Line Woes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on April 18, 2007 at 17:12:31 from (64.12.117.8):
In Reply to: Super C Fuel Line Woes posted by A. Bohemian on April 18, 2007 at 16:42:36:
The 5/16 fuel lines were used on a lot of vehicles that had carburetors. They used inverted flared steel tubing similar to brake lines. You could use a brake line if you are using inverted flared fittings. If you need to cut a line for size it would need to be double flared and any cutting needs to be done with a tube cutter. The easiest thing to do is to install a flexible neophrene hose and use the push on barbed fittings. The push on fittings come in inverted male flared or the regular female flared for connecting to to a male flared fitting. We used these in at work for years. Alemite, Weatherhead or Aeroquip has the hose and fittings. Hal
Replies:
- Thanks. A. Bohemian 17:29:07 04/18/07
(2)
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|