Re: Basket Case Tear Down Part 3

Posted by Janicholson on May 02, 2007 at 05:59:09 from (199.17.6.122):

In Reply to: Basket Case Tear Down Part 3 posted by neblinc on May 02, 2007 at 05:41:50:

Clean the bore above where they will be moving. If they begin to move, then push them both directions and clean the scrapings ahead of them on the way out. do not hit on the rods at all. Use hardwood or brass to apply force to the pin bosses from below, and a capped pipe to push from above (just smaller than the ringland, and carved to fit popup parts of the piston if any). Pulling the crank out of the engine may be necessary to get to the 2-3 bolts. Do not use a "bigger" hammer, swelling the piston/s can crack the bores and ruin the block. Good luck, and be patient. JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]