|
Farmall & IHC Tractors Discussion Board |
Farmall 400 Locked up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by TexasTedT on May 03, 2007 at 07:04:19 from (67.142.130.37):
I am not sure what has happened, but I need help! I have an excellent 400 that has been running fine. While I was mowing with a brush hog, the tractor just seemed to lock up. I had stopped and was taking off when it happened. The motor (gas) will turn over only a click at a time. The PTO will not turn in either the engaged or disengaged position. I tired to remove the PTO housing, but it will not slide out from the back of the rear end. Dropped the oil pan to see if a connecting rod had broke, but all were OK. Any help will be much appreciated. Phone is 281-615-2545.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
