|
Farmall & IHC Tractors Discussion Board |
IT shop manuals
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Butch WI on May 11, 2007 at 07:16:34 from (69.179.89.120):
I have a 460 utility and I'm wondering if the I&T shop manuals (IH-25) for the 460, 560, 606, 660, 2606, will have the 460 Utility info in it? I have heard that there is a separate owner/operators manual for the utilities. I see that the 00 and 50 series are all included in the IH-10 I&T (rowcrops and Utilities alike). I just drained the hyd oil (7.5 gals) slightly discolored and replaced with a new filter and 10 gallons of Hy-Tran Super? or supreme (don't recall the last word) and a new filter. the 2pt still wont lift on its own unless its at half throttle or more. It is Very touchy to get in the right position. I wish to use it to spread manure but am concerned about accidentally bumping the lift lever and causing damage to PTO shaft are these normally that reactive to slight movements of the control lever?? Butch
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
