Re: Priming live hydraulic system on 400

Posted by JayWalt on May 16, 2007 at 21:54:34 from (70.226.7.112):

In Reply to: Priming live hydraulic system on 400 posted by Big Country on May 16, 2007 at 19:02:59:

i think the 400s are differnet from my 300u, but I did as wardner said. I cracked the hardlines at the pump and pressurized the resevoir until oil could be seen at the pump, then tightened her up and shes good to go!!

If the pump has been apart make sure u used plenty of assembly lube, if you didnt, take it back apart and lube it, not worth ruining the pump from lack of initial lube. If the pump has been sitting dry for some time (like years), I would defintiely pressurize the resevoir, probably while cranking the engine a bit to get the pump going (unhook the coil power wire or something).

Replies:

• Re: Priming live hydraulic system on 400 JayWalt 21:55:38 05/16/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]