Farmall & IHC Tractors Discussion Board |
Re: 2 way hydraulics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wild Bill on May 31, 2007 at 13:30:24 from (63.147.9.42):
In Reply to: Re: 2 way hydraulics posted by Pat-CT on May 31, 2007 at 13:21:43:
you will need a two way open center valve (like for a log splitter) for each purpose. Don't mess around trying to find an original IH two way valve, they are out there but way to expensive. You can get a double spool and run both with it. Just make sure it is two way open center. tap any of the ports on the belly pump, pipe it to the valve, then plump the return back to the belly pump resevoir, either into the fill pipe, or drill out your drain plug, tap to a larger size and plumb it in there. Happy tractoring and be careful!
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|