|
Farmall & IHC Tractors Discussion Board |
Cub Wont Start After Belt replacement!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by kc2202 on June 05, 2007 at 07:56:54 from (68.50.54.221):
I have a 49 Farmall cub. The tractor ran fine until the fan belt broke. I did not realize it broke until I saw a little steam from the engine. I immediatly shut it down. I suspect it only ran about 5-10 min. with no belt. I replaced the belt but now it will not start. It has a full tune up and i checked the point gap and timing many times. When trying to start it smokes white a little. I had it started one time and it ran badly for a few min. and shut back down. when replacing the belt i had to remove a linkage that i belive went to the governor. I read somewhere that someone removed that linkage on thier tractor and it did the same until they put the governor back in time. Could that have put the governor out of time? or do i have another problem?? Any help would be greatly appreciated. Thank You!
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
