Farmall & IHC Tractors Discussion Board |
Questions on overdrive and misc. on 1938 F-14
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by migraine on June 06, 2007 at 08:50:09 from (71.231.54.158):
Just got a 38 F-14 in with 2 speed mounted between clutch and trans. with rod going through back to L shaped handle to shift. This handle sits next to the steering column and the box has numbers H262-1 on it. Can't see any other nos. but they may be there under the dirt or? Has gas starting tank on top with cutoffs changed to rubber and has hydraulic lift mounted on floorboard. Runs good but needs some carb. work.Just curious what 2 speeds they used back then and how these tractors were set up. Supposed to have overbore kit from a Super C in it and has had quite a bit of other work done on it the last few years. Thanks for any help and insight you can give me. Migraine
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|