Re: 434/424 tractor - PTO shaft not driving implement

Posted by Fromjb2 on June 15, 2007 at 20:54:59 from (74.101.67.211):

In Reply to: 434/424 tractor - PTO shaft not driving implement posted by Tony from Sussex on June 15, 2007 at 14:08:04:

Hi Tony, had a 434 that did the same thing. Could put the PTO into gear by shutting the engine off, engage the PTO then hold the clutch all the way to the floor and start the engine.
First of all adjust the clutch pedal to the proper free travel of 1/2 inch and 7 inches from the floor plate. If that doesn't fix the PTO then
the problem could be the adjusting bolts on the clutch fingers. It has been more than 30 years and am trying to remember exact setup. There is an adjusting bolt on each clutch finger and after many years of use the head of the bolt wears a V groove in the clutch finger, so if you turn each bolt 1/4 turn then the bolt head is no longer in the worn V groove and the fingers will now disengage the PTO clutch when the clutch pedal is all the way to the floor.

Hope this helps
JimB

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]