|
Farmall & IHC Tractors Discussion Board |
Re: Re: F-12 Oil Pan
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MikeH-Tx on February 01, 2002 at 15:04:01 from (144.189.248.170):
In Reply to: Re: F-12 Oil Pan posted by Bigdog on February 01, 2002 at 12:00:03:
There should be three of them, bottom middle and top. In distillate days, you would first fill the oil until it runs out the middle one. After using distillate for awhile, the oil gets thinned by unburned fuel seeping past the rings and increases the level of fluid in the pan. Open the top one, and if fluid comes out it is time for action. Open the bottom one, drain out whatever comes out, close the bottom and open the middle. Fill until it comes out the middle and you are good to go. Modern gasoline burns completely enough that you can ignore all this and just fill to the middle petcock.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
