Farmall & IHC Tractors Discussion Board |
Re: Okay older fellers, your turn!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by lcbateman on February 12, 2002 at 09:14:10 from (206.71.120.1):
In Reply to: Okay older fellers, your turn! posted by ff316 on February 12, 2002 at 08:37:48:
I am 42 years old. I first rode with my father and grandfather at about age four on the '52 H and '48 M on the family farm in Northeastern NC. I remember being allowed to drive the H solo when I was six or seven (in first gear, near idle) for the folks to gather corn by hand and throw into a trailer behind the H. Later, I drove the M discing while my father would row with the H. Also put in my share of time spraying and cultivating with both tractors. Both tractors left the family around 1975 when my father got out of farming. I was fortunate to regain ownership of the M about two years ago. The M was in extremely poor condition and is undergoing a complete restoration. I also have an oppurtunity to regain ownership of the H. My uncle has it and will hold it for me until I am ready. I have only been into old iron restoration for about a year. I have had many hobbies in the past, but this has been the most rewarding of all. My father just turned 74 a couple of weeks ago. He lives 40 miles from me and likes for me to keep him posted several times a week as to the M's restoration status. Even though he is not participating "hands-on", it has been very rewarding keeping him involved with the restoration of the tractor he spent so many hours driving years ago. In conclusion, I think that I am now addicted for life in the preservation of American farming heritage. You folks should be seeing my name quite regularly in the posts of Yesterdays Tractors.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|