|
Farmall & IHC Tractors Discussion Board |
Setting stop clips on Super A Touch Control
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Al on February 19, 2002 at 18:08:50 from (63.175.62.43):
I got my Super A back, had all new seals and other goodies installed in the
final drive and transmission, and my mechanic went through the Touch Control---it had no external leaks but an implement would drop if you left
it raised and shut the engine off. When he got inside he found some things
somewhat damaged, didn't go into specifics but got everything working
"right" again. (Had to fix what was there as some parts are NLA.) He did
not adjust the stop clips that control how far forward the levers will go,
and I need to get that done so that I won't burn something up. According to
the service manual, I need a SE-1338 gauge, which you insert in the 1/4"
hole on the touch control manifold. I think that translates into a high-pressure gauge. Can I find something like this at say, Northern Hydraulics or an auto parts store?
The service manual covers setting the stop clips pretty well. Any other helpful hints? I am hoping once I get them re-set and adjust the lengths of
the operating rods, the levers will go in their full-forward positions as original. One more thing: The levers are very tight when moving them rearward, not so
tight when you move them back forward. Is this normal and just a function
of all-new O-rings? Thanks,
Al
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
